Omron FH series User Manual page 444

DOPORTCOND or DPC
Sets the ON/OFF states of all parallel DO terminals at once.
For how to set the DO terminal status, refer to the following:
Example)
When you set the parallel DO terminal status of Line 0 to ON:
1. Set the command which turn the terminal status ON to the parallel DO terminal of assignment BIT.
2. Sends the command which you set the above step 1 to the port number of Line o.
3. Executed result is responsed.
<Command format>
or
<Response format>
When processing is performed normally
When processing is not performed normally
<Parameters explanation>
Specify the DO terminals to switch ON (0-65535).
• 1st bit: DO0
Terminal state • 2nd bit: DO1
:
• 16th bit: DO15
IMPORTANT
Sending this command to the each lines assigned port number, can set the specified terminal status.
When you set the unusable or different terminal status of lines, the response code is OK and the status is be disposed.
Make sure to check the acquired data by actually changing the parallel terminal status.
(Example)
When setting DO0 and DO4 ON
<Command>
<Response>
442
Command Control Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)