Omron FH series User Manual page 358

Restarts the Sensor Controller
Clear Error
Clear Parallel OR+DO
*1: You can execute the same operation with the Measurement Execution Bit (STEP signal is allocated for both the parallel
communications and EtherNet/IP) in the control signals.
*2: You cannot execute tag data link commands. Execute the command with message communications.
*3: You can execute the same operation with the Error Clear Bit (EtherNet/IP: ERCLR, EtherCAT: Error Clear) in the control
signals.
356
Command Control
OK: Applicable command, RST: Command with restricted execution, NA: Non-applicable command
Function
Parallel PLC link EtherNet/IP
Reference: Reference: Reference:
(p.333) (p.199)
NA OK
OK NA
OK NA
Vision System FH/FZ5 Series User's Manual
for Communications Settings (Z342)
Non-
EtherCAT
procedure
Reference:
Reference:
(p.251) (p.81)
(p.292)
OK OK OK
*3 *3
NA NA NA
NA NA NA