Omron FH series User Manual page 236

4
Click the [...] button next to the expression box and set the expression.
Specify the processing items, measurement results, and measurement data in the expression.
You can also perform arithmetic or function calculations on the measurement data before it is output.
For calculation settings, refer to section of Calculation in FH/FZ5 Processing Item Function Reference
Manual (Cat. No. Z341).
5
Click the [...] button for the [Comment] box and enter an explanation of the expression.
The comment you enter will be displayed in the detailed results on the Main Window.
For example, if you enter "Test" as the comment for expression 0, "Test" will be displayed in place of
"Expression 0" in the detailed results area on the Main Window.
6
Repeat steps 4 and 5 to set expressions for all of the required output data numbers.
Note
If you delete one of the expressions that is set for output data 0 through 7, the output numbers for all expressions after the
deleted expression will stay the same. However, the actual data output will be output as though the list has been shifted
forward for the number of expressions that have been deleted.
To prevent data from being written to the wrong locations, use copy and paste to shift the expressions after the deleted
number forward.
For details on the Data Output Area, refer to
Example: If the Expression for Output 1 Is Deleted
Output Item Settings
Output Item Settings
234
Communicating with EtherNet/IP
Memory Allocation (p.238).
Output 1 is deleted.
Data Output Destination (Data Output Area)
Bit
First word
15
+8 DATA1 (Reference SX)
+9
+10 DATA2 (Reference SY)
+11
+12 DATA3 (Reference angle ST)
+13
Data Output Destination (Data Output Area)
Bit
First word
15
+8 DATA1 (Reference SX)
+9
+10 DATA3 (Reference angle ST)
+11
+12
+13
The output numbers assigned to the
expressions remain the same, but the data
output location is shifted forward for data 3.
Vision System FH/FZ5 Series User's Manual
to 0
to 0
for Communications Settings (Z342)