Omron FH series User Manual page 275

Hide thumbs Also See for FH series:

Table of Contents

Set the following items.

• The following series with 4 or 8 camera inputs has two Ethernet ports:

• FH-1000 series

• FH-3000 series

Set the settings for the two Ethernet ports as follows:

• Communications Module settings

Use the same setting for both ports.

• IP address settings

Set a different IP address for each Ethernet port.

The IP address for the top Ethernet port is set in [Address setting], and the IP address for the bottom Ethernet port is

set in [Address setting 2]. By using both Ethernet ports simultaneously, you can use one for PLC Link, non-procedure,

Ethernet, or IP communications with a PLC and the other for FTP or remote operation communications with an

external device.

• The following Sensor Controller type has one Ethernet port:

FH-1000/FH-3000 series with two camera inputs

In this case, the IP address of the Ethernet port is set in [Address setting 2].

• The FZ5 has only one Ethernet port.

In this case, the IP address of the Ethernet port is set in the [Address setting].

Vision System FH/FZ5 Series User's Manual

for Communications Settings (Z342)

Non-procedure Communications

Troubleshooting