Overhauling A Vokes Air Filter; Overhauling A Miofilter Filter - CITROËN ID 19 Repair Manual

ID19 OPERATION No. ID 17 l-3
: hduuding an airfihei
Op. ID 171-3 93
OVERHAULING A VOKES AIR FILTER (see PI. 29).
Dismantling.
NOTE - It is essential to clean the filter element every 3, 750 miles (6, 000 kms) ( car operating in normal road
conditions).
Undo the winged nut (l), remove the end cover (Z),
element (4). Withdraw the filter element (4ff
withdraw the inner tube assembly (3) complete with filter
rom the tube (3). Remove the felt joints (6), (7) and (8).
Clean the components. Holding the filter element vertical, remove dust by tapping it gently at the edges with the
hand.
Assemblv.
Fit the filter element (4). Fit the felt joints (6), (7) on the pipe and inner tube assembly (3).
Insert these components into the air filter body (5). Replace the cover (2) complete with felt joint (8). Arrange the
position of the rear fixing bracket (9) in relation to the front fixing bracket (10) and tighten the wing nut (1)
(plain washer).
Ensure that the felt joints are glued in position.
If not, glue them again with glue EC 847, sold by the
Societe MINNESOTA de FRANCE, 135, boulevard Serrurier, Paris (19e). Telephone No. BOL 71-79 and
BOT.42-80.
NOTE - For efficient operation the edges of the filter element must be correctly seated
on
the felt gaskets
(7 and 8).,Make sure that the element is sufficiently compressed by the cover, if not, insert a second
felt gasket (7), which should be stuck to the first (EC 847 glue).
OVERHAULING A MIOFILTER FILTER (see Pl. 28).
Dismantling.
NOTE - It is essential to clean the filter element every 3, 750 miles (6, 000 kms) ( car operating in normal road
conditions).
Unscrew the wing nut (1) and remove the serrated washer (2).
Remove the front cover (3) complete with felt joint (4) and withdraw the filter element (5) complete with cork
gaskets (9).
Remove the rear cover and pipe assembly (6) from the air filter body (7).
Remove the felt joint (8) from the rear cover and pipe assembly (6).
Clean the components. Wash the filter element (5) in petrol and then dip it in engine oil and leave it to drain.
Brush the filter element (5) and blow it with compressed air.
TOOLS