CITROËN ID 19 Repair Manual page 254

248 OPERATION No. ID 433-4
: Work on
the
front suspension ID 19
TOOLS
20
Refitting (see
Pl. 79
and 80).
Place each lower bearing (23) in its bearing block, the longer part on the engine side and insert the cotter in its
housing. Rest the anti-roll bar on the bearing.
21 Check the adjustment of lateral position of the anti-roll bar (see Op. ID 433-O) and make any necessary adjustments.
22 Adjust the right-hand anti-roll bar bearing (see Op. ID 433-O).
23
24
25
26
27
28
29
30
Check the side clearance of the anti-roll bar. It should be such that "k" = 0. 05 mm between the stop (24) and the
lower left-hand bearing (23), the right-hand stop (25) being in contact with the bearings of the right-hand bearing
block. If necessary, shift the left-hand stop (24) to obtain the correct clearance . . . . . . . . . . . . . . . . . . . . . . . . , . . .
Adjust the left-hand bearing (see Op. ID 433-O).
Remove the bearing caps
(16). Smear
the bearing (23) with graphite grease and refit the bearing caps.
Tighten the "II" bolt nuts to 8.5 ft. lbs (1.2 m. kg) (spring washers).
Check the torque of the anti-roll bar: it must rotate under a force of 9 to 13 lbs (4 to 6 kg. ) applied at the ball joint;
if not, change the adjusting washers (22) of the bearings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Connect the anti-roll bar to the front half-axles (see paragraph 8, this operation).
Make the provisional height adjustments (see Op. ID 433-O).
Refit the front wheels and lower the car to the ground (jacking bracket 2505-T, see PI. 111). Tighten the wheel fixing
screws to 108 to 144 ft.lbs (15 to 20 m. kg) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Adjust the heights (see Op. ID 433-O).
Fit the side protection panels, the front wings, the spare wheel support and the spare wheel . . . . . . . . . . . . . . . . . . . . .
12 mm box spanner
12 mm box spanner
Jacking bracket 2505-T
8-12-14 mm box
spanners