CITROËN ID 19 Repair Manual page 263

ID 19 OPERATION No. ID 437-
1 : Replacement
of
a manual
height control
Op. ID 437-l 257
5-7
13-14
15
16
PARTICULAR POINTS
Removal
Remove the connecting rods
from
the
front of
the car (hole provided
for
the front connecting rod).
Assembly
Fit the quadrant in position, the$xing screws in the centre
of
the slots. Put the lever in the "normal" position.
To adjust the control (see PI. 83).
Distance "b" = 7.5 to 9 mm., adjusted by selecting a hole "a"
on
the front connecting rod.
If necessary move
the quadrant in its slots.
Distance "d" = 8 to 9.5 mm., adjusted by selecting a hole "a" on the rear connecting rod.
If
necessary aa!just the rear yoke (31)
Distance "e" = IO to 15 mm., (with the central lever in the low position) the dimension is taken between the sidemember
and
the knob
of
the control lever.
If
necessary adjust the lever.
To check the adjustment
of
the corrector control levers:
Make sure that there is a clearance between the nut
of
the control rod and the corrector control lever the slide valve being at the bottom
of
the inlet or outlet stroke. If necessary adjust the nuts on their rod.
REMOVAL (see Pl. 83).
Jackup the left-hand side of the car.
Remove the left-hand front and rear wings and wheels.
Remove the side protection panels of the front and rear
correctors
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the pin from the spindle (19) coupling the front connecting rod (20) and the rear connecting rod (21) to the
control lever. Remove the connecting rod and the spindle (19).
Remove the screws securing the quadrant (23) on the side scuttle panel and release the quadrant.
Unscrew the nut (24) on the locking screw of the bell crank lever (25).
Remove the assembly of the lever (25) and quadrant (23). Disengage the lever (22) from the support (27) welded on
the body. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Unscrew the nut (28) and disconnect the front connecting rod (20) f rom the front torsion rod (29). Remove the
connecting rod(20)andthe sleeve seal(30)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the rivet securing the yoke (31) of the rear connecting rod to the torsion rod (32). Unscrew and remove the
yoke (31).
TOOLS
8- 12- 14 mm box spanners
8 mm box spanner
8 mm box spanner