CITROËN ID 19 Repair Manual page 79

ID
19
OPERATION No. ID 133- 1 : Work OYZ the enpine suspension
Op. ID 133-1
77
10
16
30to3
37
40
PARTICULAR POINTS.
Replacement of an upper front crossmember.
Assembly.
Insert shims between the crossmember and sidemembers. The distance between the brake disc and the sidemember, on the left hand side, must be
70 f 2 mm greater than this same distance on the right hand side.
Fill the radiator.
I
Replacement of a rear flexible mounting (cars produced until July 1959).
Dismantling.
The threaded shaft ,must be removed from underneath the car, while the flexible mounting must be removed from above the car. Before carrying
out these operataons, measure the distance "a" (see IY.25) between the bearing face of the engine support arm at the level of the top nut, and the
face of the flexible mounting which bears against the steel plate support fixed to the body.
Assembly.
Insert the threaded shaft (fitted with parts comprising the lower assembly), f rom underneath the car, into thef7exible mounting and tighten the top
nut of the engine support arm, until1 the distance "a" measured during dismantling has been obtained.
Check the adjustment of the engine mountings (see Op.ID 133-O).
Replacement of a rear flexible mounting (cars produced since July 1959).
The flexible mounting and the rear engine support must be removed together.
Pre-adjustment of a rear flexible mounting (cars produced until July 1959).
Place the rubber washer against the flexible mounting support and tighten the lower cupped nut eight turns (10 mm).
Pre-adjustment of a rear flexible mounting (cars produced since July 1959).
Adjust the lower nut, to obtain a distance of 98 mm between the upper face of this nut and the lozoer face of the flexible mounting which bears against
the support fixed to the body.
Replacement of a rear support (cars produced until July 1959).
__-
Dismantling.
The flexible mounting must be removed with its threaded shaft (see above).