Replacement Of A Handbrake Lever - CITROËN ID 19 Repair Manual

ID 19
OPERATION No. ID 454- 1 : Work on the mechanical brake control Op.ID 454-l 303
10
14
15
24
33
.
PARTICULAR POINTS
Replacement of a brake handle.
When assembling, secure the release trigger to the brake handle so that the release control rod does not slip out of its guide hole (on the release trigger).
To adjust the unlocking mechanism: press the release trigger, turn the adjusting screw of the release control rod until the handle is unlocked.
Adjust the control cable (see OP. ID 4.54-O).
Replacement of a handbrake release trigger.
Remove the handbrake handle in order to carry out this operation.
Replacement of a locking ratchet.
Secure the release trigger to the brake handle, see paragraph 10. Rotate the ratchet in order to remove it.
TOOLS
REPLACEMENTOFAHANDBRAKELEVER
Removal (see P1.109-110).
Remove the glove compartment and remove the central instrument board plate (do not mislay the rubber buffer of the
glove compartment lid).
Remove the upper panel of the instrument board.
Remove the instrument panel lower metal plate and remove the
lower beading.
Unscrew the left hand ventilator control lever knob and remove the ventilation grille.
Remove the seal from the air duct,
remove the screws securing the air duct to the instrument board and withdraw the
air duct towards the rear.
Remove the spare wheel and the left hand front wing.
Remove the left hand front side protection panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Unscrew the locknut (23) locking the threaded sleeve (24)
and screw up the threaded sleeve (24) in order to slacken the
cable (3) as much as possible, the threaded sleeve (24) can be rotated by hand . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the split pin (4) from
the pin (5) securing the control cable (3) and drive out the pin.
Remove the split pin (6) from the brake trigger pivot Screw (7).
Remove the nut (8), holding the screw (7) firmly,
and remove the strew(7) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the hand brake trigger by pulling it downwards. Take care not to lose the hollow shaft (9).
8-12-14mmbox spanners
21 mm spanner
14-17 mm box spanners