Petrol Pump - CITROËN ID 19 Repair Manual

98
OPERATION No. ID 174- 1 : Replacement of a petrol feed pipe
ID 19
1
2
3
4
5
6
7
8
9
10
11
12
13
REMOVAL.
Jack up the front of the car on wedges (jacking support 2505-T, see Pl. 111). Remove the right-hand front wing
and the side protection plate
. ..*........s..........
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the lower right-hand sidemember closing panels.
Undo the fixing screws and remove the rubber protectors from the straps securing the petrol feed pipe to the right-
hand sidemember and sill and to the front crossmember under the engine (lower part). Withdraw the pipe
from the straps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the squab and rear seat. Remove the petrol tank cover plate
. . . . ..*..*..............................
8 mm box spanner
12 mm box spanner
Remove the petrol feed pipe together with the rubber hose from the tank and from the opening on the rear part of
the sidemember.
Remove the rubber connecting tube to tank from the petrol feed pipe. Disconnect the front rubber union from the
petrol pump and remove the union from the feed pipe.
Disconnect the front part of the feed pipe from the front crossmember under the engine, from the right-hand sill
and from the front closing panel of the right-hand sidemember.
Disengage the pipe from the sidemember by pulling it towards the front.
REFITTING.
Close the front and rear openings in the petrol feed pipe. Drain the tank
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Engage the rear part of the pipe in the hole in the front closing panel of the right-hand sidemember, fit the pipe
in the straps on the sidemember.
.c
. 21 mm box spanner
With the narrow part of the feed pipe towards the rear, slide on the rubber connecting pipe towards the front of
the narrow part of the feed pipe, with the rear end of the rubber pipe 370 mm from the rear end of the feed
pipe,
Use talc only for sliding the pipes.
Insert the rear end of the feed pipe in the tank and carefully couple the rear end of the rubber hose on the tank
connection. Cut the rear end of the feed tube obliquely and insert the drain plug (insert the seal) . . . . . . . . . . . . .
Fit the petrol tank cover plate.
Tighten the fixing screws (plain washers under the heads).
Paste the sill trimming (Glutafix T paste, sold by Messrs. Bessier, 125, Rue de Reuilly, Paris lZe) on the
petrol tank cover plate.
21 mm box spanner
t Put the rear squab and seat in position . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
12 mm box spanner
TOOLS
Jacking support 2505-T
8-12-14 mm box spanners