CITROËN ID 19 Repair Manual page 275

ID 19 OPERATION
NO.
ID 443- 1 :
Work on the steering relay Op. ID 443-l
269
5
Mark the position of the steering in the relay bearings, with a spot of paint
(at "b" see PI. 93), 1 ower the steering and column assembly slightly
before removing the relays.
Assembly.
11
This operation is only carried out when replacing the body, the front of the body or repairs to the body, it is then necessary to adjust the
13
16-17
24
position of the selay assembly (see paragraph I I).
If
only replacing the relays, refit the adjusting washers found when dismantling.
When refitting the steering, note the markings made when dismantling.
Adjust the track and the steering lock (see Op. ID 440-O).
Replacement of a lower relay lever (on the car).
Tightening of the nuts:
PARTICULAR POINTS
Removal.
Tightening the nut of the lower bearing and lock by hammering down the metal.
Tighten the nut of the upper bearing to 43 ft.lbs. (6 m.kg.) at the same tzme turning the relay spindle; loosen the nut and retighten to 14 to
22 ft.lbs. (2 to 3 m.kg.), lock the nut by hammering down the metal.
If the work has been made necessary because of seizure of the relay ball joint,check the operation of the other ball joint and the coupling levers on
the pivot.
REPLACEMENT OF A STEERING RELAY
Removal (see Pl. 9 1 and 94).
Remove the spare wheelandthe support . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Jack
up the front of the car (jacking bracket 2505-T, see Pl. 111).
Remove the left hand front wing.
Remove the front wheel on the side where the relay is to be replaced.
Disconnect and remove the battery. Remove the battery tray . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the instrument panel cover.
Have the steering wheel turned so that the screw (4) of the collar (5) is in such
a position that it can be unscrewed (see P1.91). Unscrew the
screw (spanner 1994-T,
see P1.91, fig.3) . . . . . . .
Make a paint mark (at "b",
see Pl. 93) to show the position of the steering assembly in its bearings.
TOOLS
12 mm box spanner
12 mm box spanner
Spanner 1994-T