CITROËN ID 19 Repair Manual page 260

254 OPERATION No. ID 434-4
: Work on the rear suspension
ID 19
T
4
5-6
11-l.
PARTICULAR POINTS
Replacement of an anti-roll bar.
The clearance between the anti-roll bar and the rear hub should be set equally on both sides.
Check and adjust the heights.
Replacement of a corrector control rod.
Check and adjust the heights.
TOOLS
REPLACEMENT OF AN ANTI-ROLL BAR
Removal (see P1.81).
Release the pressure by unscrewing the pressure control valve bleed screw and set the manual height control lever
in the "low" position. Jack up the rear of the car (jacking bracket 2505-T, see Pl. 111) . . . . . . . . . , . . . . . . . . .
Remove the rear corrector control protection panel (on ID 'lConfort" models the rear seat squab must also be removed)
Disconnect the flange (9) of the rear corrector control rod (10) from the anti-roll bar.
Remove the coupling flanges (11) from the anti-roll bar and withdraw the bar
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Refitting (see P1.81).
Fit the anti-roll bar so that the clearance between the anti-roll bar and the rear hubs is the same on both sides.
Fit
the coupling flanges (11) and tighten the flange fixing nuts
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the rear corrector side protection panel and make preliminary adjustment of the heights (see Op.ID 433-O)
Adjust the heights (see Op.ID 433-O).
Fit the corrector control protection panel and fit the corrector side protection panel
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
REPLACEMENTOFACORRECTORCONTROLROD
Removal (see P1.81).
Release the pressure by unscrewing the pressure control valve bleed screw and set the manual height control lever in
the "1ow"position . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
8 mm spanner
Jacking bracket 2505-T
8 mm box spanner
12 mm spanner
12-19-21 mm box
spanners
9-21 mm box spanners
8 mm spanner and
box spanner
8 mm box spanner
8 mm spanner
&