CITROËN ID 19 Repair Manual page 84

82 OPERATION No. ID 133- 1 :
Work on the engine suspension
ID 19
TOOLS
41
42
43
44
45
I
Assembly.
I
Fit the arm on the previously adjusted flexible mounting (see paragraph 49) and screw the upper nut securing the
arm(lockwasher) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fit the flexible mounting and support arm assembly on the engine.
Fit and tighten the screws securing the flexible
mounting and the support arm,
after placing correctly the following parts (spring washer under the heads of
the screws securing the arm, plain and spring washers under the heads of the screws securing the flexible
mounting) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Left-hand side : hook on the distributor return spring.
Right-hand side : fit the exhaust manifold screen.
Tighten the fixing screws (plain washer under the head of the
screw) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
REPAIRING A FLEXIBLE ENGINE MOUNTING
( cars delivered until July 195.9)
23 mm box spanner
14-17 mm spanners and
box spanners
12 mm box spanner
Dismantling (see Pl. 25).
Remove the spindle (B), the rubber and fibre washer (9), the rubber block (1 I), the locknut (12) and the cupped nut
(5).
Glean the parts.
Fitting (see Pl. 24).
On the spindle (8) fit the rubber and fibre washer (9), the rubber block (1 l), the cupper nut (5) and the locknut (12).
PRE-ADJUSTMENT OF THE REAR FLEXIBLE ENGINE MOUNTING
( cars delivered until July 1959)
(see Pl. 25).
46 Tighten the cupped nut (5)
until the rubber washer (9) comes into contact with the face "d" of the support (4).
The washer (9) must turn freely without play., . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
47
48
23 mm box spanner
Holding the spindle (8) by the nut (6) f ixing the cup (7), tighten the cupped nut (5) giving it eight complete turns,
which corresponds to a movement of 10 mm...........................................................
23 mm spanner and.
box spanner
Tighten the lock and locknut(12) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
23 mm spanner and
box spanner