Replacement Of A Clutch Fork; Replacement Of A Clutch Thrust Ball Bearing; Replacement Of A Thrust Ball Bearing Hub - CITROËN ID 19 Repair Manual

ID
19 OPERATION No. ID 314- 1 :
Work on rhe clzlrch Op.ID 314-1 137
REPLACEMENT OF A CLUTCH FORK
Removal (see Pl .49)
1
Remove the gearbox (see Op.ID 330-l).
2
Remove the rubber closing plate from the clutch withdrawal fork opening.
3
Remove the clutch thrust bearing retaining sptings (89). Remove the bearing.
4
Remove the retaining screw (91) of the clutch fork shaft (92).
Remove the shaft (92), spring (119) and the fork . . . . . . .
Refitting (see Pl .49)
5
After oiling, insert the shaft (92)
in the right hand bore and place the fork, complete with return spring (119) in
position. Tighten the retaining screw
(91)
of the shaft (92) (spring washer under the head) . . . . . . . . . . . . . . . . . . . .
6
Place the thrust ball bearing in position and secure to the fork by means of the springs (89).
7
Fit the rubber closing plate for the clutch withdrawal fork opening.
8
Replace the gearbox and connect to the engine (see Op.ID 330-l).
REPLACEMENT OF A CLUTCH THRUST BALL BEARING
Removal (see Pl .49).
9
10
11
12
13
14
Remove the gearbox (see Op.ID 330-l).
Remove the springs (89) retaining the thrust bearing. Remove the thrust bearing from its hub (93).
Refitting (see Pl. 49)
~___
_.
Place the thrust ball bearing in position and secure it to the clutch fork by means of the springs (89).
Fit the gearbox and connect it to the engine (see Op. ID 330- 1).
REPLACEMENT OF A THRUST BALL BEARING HUB
Removal (see PI.
49)
Remove the gearbox (see Op.ID 330-l).
Remove the springs (89) securing the thrust ball bearing. Remove the thrust bearing.
TOOLS
8 mm box spanner
8 mm box spanner