CITROËN ID 19 Repair Manual page 219

ID 19
6
OPERATION No. ID 413-O
: Adjustment to the front pivot
Op. ID 413-O 213
T-
Place under each contact screw
(B) one of the adjusting washers (6) found when dismantling. Screw up each contact
screw (B) until the washer passes freely and without play under the point.
Lock the screws (b) with the locknuts (C). Remove the fixture from the lever . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
T
Fit the fixture on the new lever.
From among the adjusting washers sold by our ware Parts Department choose those which will pass freely under
the point of the screws
(B) in the same conditions as in paragraph 5.
Mark the position of the adjusting washers. Remove the fixture.
2nd CASE.
Adjustment using a dial gauge (see paragraphs 1 to 4, this operation).
TOOLS
Fixture 1867-T