CITROËN ID 19 Repair Manual page 304

298
OPERATION No. ID 453-3 : wmk on t/ze hydraulic bruk system
ID 19
OVERHAULING A PEDAL GEAR
Dismantling (see Pl. 107).
21
22
To remove the accelerator pedal (see Pl. 27) :
Unlock the locknut (12), unscrew the screw (13) and withdraw the accelerator pedal (10) . . . . . . . . . . . . . . .
Remove the adjusting nuts (10) of the stop light switch control (9).
Remove the contactor fixing screws and withdraw the contactor.. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
. .
23 Remove the dust cover.
Remove the key securing the clutch pedal on the pedal shaft.
24
Drive out the pedal shaft, remove the springs, the pedals and the distance piece .................................
Drive out the bushes (1 l), from the pedal bracket and from the brake pedal (use a shouldered mandrel) ............
25 Unlock the locknut (8) of the master cylinder control rod (7), unscrew the rod and remove . . . . . . . . . . . . . . . . . . . . . . . .
Assembly (see Pl. 107).
26 Place the bushes (11) in position in the pedal bracket and in the brake pedal (shouldered mandrel, using a press,
see paragraph 24above).................................................................................
27
Place the parts in position in the pedal bracket in the following order: the brake pedal, the brake pedal spring, the distance
piece, the clutch pedal spring, the clutch pedal and engage the shaft, previously oiled in each of the
parts.
Put the clutch pedal key in position. Tighten the nut (plain washer).
Fit the bentend of the springs onthe pedals . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
28
Fit the stop light switch; engage the switch on the control rod (9), fit the adjusting nuts (lo), fit and tighten the fixing
screws (spring washers under the heads).
TOOLS
17 mm spanner
7 mm spanner and
box spanner
12 mm box spanner
Shouldered mandrel :
Small dia. = 17.5 x50
long.
Largedia.=21.5xlZOlong
16 mm spanner
Shouldered mandrel
12 mm box spanner