CITROËN ID 19 Repair Manual page 214

208
OPERATION No. ID 410- 3 : Ovevhau~ing a front
half-axle.
d) Remove the seals (25) and
(26)
f rom the upper arm hub and the seal (27) from the hub of the lower arm.
e)
Remove the taper roller bearing races.
f )
Remove the oil seal washer (28) from the arms.
To strip the arm bracket:
a)
Clean the arm bracket.
b)
Using a gas blowpipe, gently heat the bracket round the outer races. Drive out the races.
lightly with a sharp edged tool.
Remove the castor angle adjusting washer (29).
To strip the suspension buffer arm (see Pl. 79).
a) Remove the rubber buffer (38).
If necessary tap them
b)
Remove the adjusting nut
(39)
from the ball joint on the connecting rod of the anti-roll bar (spanner MR-3691-40,
see Pl. 64, fig.4). Remove the cup (40) and the ball (41) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
NOTE - If wear is pronounced, the buffer arm must be renewed.
To dismantle the pivot (see Pl.
62).
4
b)
4
d)
e)
f )
Drill through the centre punch marks locking the screw (9) in the ring nut (10)
securing the driveshaft (2 mm drill)
Remove the locking screw.
Place the pivot and driveshaft assembly in a vice support 1922-T,
(see P1.66, fig. 1)
. . . . . . . . . . . . . . . . . . . . . . . .
Undo the half shells (15) retaining the universal joint dust cover (11)
and remove the cover towards the splined end
With a screwdriver release the oil seal (12) from the groove in the pivot hub.
Remove the driveshaft fixing ring nut (10)
f rom the pivot hub groove as foilows:
Keep the driveshaft perfectly straight and fit the spanner (spanner 1920-T, see Pl. 66;'fig. 2). Place a tubular
extension on the spanner; the nut is tightened to 288 ft.lbs (40 m.kg).
Remove the driveshaft and nut assembly from the pivot. Remove the spring (14) and cone (13).
Remove the oil seal (12) from the splined end . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To remove the upper ball:
Remove the steering lever (1) from the pivot, retaining the adjusting washers.
Release the ball (3) and the
distance piece (4).
Extract the lower ball socket (5)
( ex ractor 1856-T, see P1.63, fig. 1)
t
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ID 19
TOOLS
Spanner MR- 3691-40
Vice support 1922-T
Spanner 1920-T
Extractor 1856-T