CITROËN ID 19 Repair Manual page 76

74
OPERATION No. ID 120- 1 : Work on timing gear
ID 19
29
30
31
32
33
34
TOOLS
Adjust the valve rocker clearances (see Op. ID 112-O).
Fit the cups (1) and the rubber joints (2) on the sparking plug tubes.
Fit the cylinder head cover, using "Hermetic" to secure the gasket to the cover only. Tighten the fixing nuts
(plain and leather washers).
Fit the air filter and tube assembly. Tighten the fixing nuts (spring washers) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
a)
Fit the front brake connection pipe in its clip, inserting a rubber ring and turn down the clip over the tube.
b)
Place the water pump and dynamo belt in position. Tension the belt, tighten the dynamo fixing screw and the
tie-rod fixing nutonthe dynamo..............................,........................................
cl
Connect the flexible petrol pipe to the carburettor.
Adjust the height of the front left-hand brake unit: turn the adjusting nuts of the front support tie-bar until the plates
project slightly to the front of the disc (about 1 mm) (seeP1. 99, fig. 1) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Insert the fixing screw for the cylinder head lubrication pipe union using a double copper joint
. . . . . . . . . . . . . . . . . . . 12 mm box spanner
Fit a covered chain round the water pump cover (chain 1697-T, see Pl. 42) and raise the engine on a pulley block.. Chain 1697-T
35 Fit the oil pump and the sump (see Op. ID 111-4, paragraphs 6 to 8).
36
Fit the distributor (see Op. ID 21 l-l, paragraphs 3 to 6).
37
Fit the engine and gearbox assembly on the vehicle (see Op. 100-1, paragraphs 28 to 57).
Fill up engine with oil - 7 pints
(4 litres SAE 20 oil).
12-17 mm box spanners
14 mm spanner
12 mm box spanner
21 mm spanner and
box spanner