CITROËN ID 19 Repair Manual page 269

ID 19 OPERATION No. ID 442- 1
: Replacement of a steering assembly
Op.ID 442-l
263
8
9
11
15
PARTICULAR POINTS
Refitting
Put the steering assembly in position, do not tighten the bearing cap fixing screws. Move the steering assembly, so that the dimensicrt "c" = 122.5
$ 2.5 mm. between the
centreline
of the rack pressure pad cap and the centreline of the lower left hand relay lever (see PI. 93).
Position the outer silentbloc bush of the left hand steering rod to give a dimension "d" =
the arm of the steering wheel being in the horizontal position.
275
mm. from the centreline of the rack pressure p@ cap,
With the front of the car raised, turn the steering wheel to the right then to the left in order to position the steering in relation to the wheel.
Tighten the bearing cap fixing
screws.
Adjust the track and the steering lock (see Op. ID 440-O).
TOOLS
REMOVAL (see P1.90 and 91).
Remove the spare wheel and the left front wing. Jack up the front of the car (jacking bracket 2505-T, see P1.lll). . .
Remove thebatteryandthebatterytray . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the instrument panel cover. Unscrew the screw (4) of the collar (5) ( p s anner 1994-T, see P1.91, fig.3) . . :.
Disconnect the flexible coupling (10) from the steering pinion (11) . . , . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Disconnect the steering levers (1) from the relay shafts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Remove the steering bearing caps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Release the steering assembly and withdraw it from the left hand side of the car.
REFITTING (see Pl.90 and 91).
Insert the steering assembly in position from the left hand side of the car.
Position the steering assembly in its bearings. Fit the bearing caps and insert the screws without tightening them
(spring washers under the heads).
Position the steering assembly in its bearings
SO
that the centreline of the rack pressure pad is at a distance of
"c" = 122.5 2 2.5 mm from the lower left relay lever (see P1.93, fig.2).
Connect the steering levers (1) to the relay shafts. The nuts must be on the outside.
Tighten the nuts to 18 ft. lbs
(2.5m.kg) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .._.........
Jacking bracket 2505-T
12-14 mm spanners
and box spanners
12 mm box spanner
Spanner 1994-T
12 mm box spanner
14-16 mm box spanners
12 mm box spanner
14-16 mm box spanners