CITROËN ID 19 Repair Manual page 123

ID 19 OPERATION No. ID 220-I : Work on the oil circulation system Op.ID 220-l 121
8
Fitting the sump:
Replace the cork joints of the front and rear bearing caps.
At front - place a cork gasket,
the ends of which must be smeared with "Hermetic".
At rear - place a cork gasket, the ends of which must be smeared with "Hermetic", and the cap groove
front sealing plate.
b)
4
If the gaskets between the sump and the cylinder block need replacing,
cut such replacement gaskets so that
they are flush with the bearing caps, using a sharp knife.
Carefully clean the mating faces of the cylinder block and the sump.
Cut the replacement gaskets to make them flush with the bearings. Smear the ends of the gaskets generously
with "Hermetic" and put them in position.
Put the sump in position and tighten the fixing bolts.
The long screws are for the front and rear bearings . . . . . . .
12 mm box spanner
9
10
Fit the distributor (see Op.ID 211-1, paragraphs 3 to 6).
Fit the engine-gearbox assembly on the car (see Op.ID 100-1, paragraphs 28 to 57).
Fill the engine with oil - 7 pints (4 litres) of SAE 20 oil.
TOOLS