This Manual includes all the main service operations. Primarily it is intended for left-hand drive cars but the application to right-hand drive cars should

present no difficulties as any differences are obvious.

CLASSIFICATION

We have shown at the beginning of this manual a classification of the main units of the car.

The three figured number in front of each unit corresponds to the operation number relating to this particular unit

METHOD OF NUMBERING

The number is composed of :

The indication of the type of vehicle : ID

A number of three figures indicating the unit or part of the unit (this number is shown in the general classification).

A code number, indicating the type of work, dealt with in the operation. These figures are separated from the number by

a hyphen.

Use of the code :

The figure 0 indicates the adjustments.

The figures 1, 4. 7 indicate the replacement of units (removal and refitting).

The figures 2, 5, 8 indicate the stripping down and assembling.

The figures 3, 6, 9 indicate the overhauling (reconditioning).

EXAMPLES :

Operation No. ID 334-0 : Adjustment of the gear selector control.

Operation No. ID 372-1 : Replacement of a driveshaft or a pivot.

Operation No. ID 100-2 : Stripping and assembling an engine-gearbox assembly.

Operation No. ID 442-3 : Overhauling a steering assembly.

Operation No. ID 453-4 : Replacement of a pedal gear.

PARTICULAR POINTS

At the beginning of each operation the particular points are given (tightening torsions, adjustment dimensions, special assembly precautions, etc.). The

number of the line of the particular points corresponds with the number of the paragraph in the operation.

ILLUSTRATIONS

At the top left-hand corner of each illustration is shown the number of the operation concerned with this particular illustration (this information

is not given on the illustrations for the tools).

METHOD OF USING THE REPAIR MANUAL

Table of Contents