CITROËN ID 19 Repair Manual page 320

314 OPERATION No. ID 532- 1
: Replacement
of a
dynamo
ID 19
1 Remove the battery. Remove the clamping rods and protecting plate . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . , . . . . . . . . 8 mm box spanner
2 Remove the battery tray with its drain pipe.
3 Disconnect the dynamo tie-rod and remove it . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12 mm box spanner
4 Unscrewthetwo screws fixing the dynamo . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 mm spanner and
ring spanner
5 Swing the dynamo towards the engine and disengage the belt.
6
Unscrew the front fixing screws, remove the rear fixing screw and remove the dynamo . . . . . . . . . . . . . . . . . . . . . . . . . . . .
14 mm spanner and
ring spanner
REFITTING
7
Put the dynamo in position, the front fixing plate between the plain washer and the bellhousing.
8
9
10
11
Fit the rear fixing screw (spring washer under the head).
S crew up the front and rear fixing screws.
Swing the dynamo towards the engine, put the belt in position on the pulley.
Fit the dynamo tie-rod, tighten the belt moderately.
Tighten the nut fixing the tie-rod on the dynamo (plain and spring
washers) and tighten the dynamo fixing screws . . . . . . . . . . . . . . ..,.....-.........................,............
Fit the battery tray, fit and connect the battery. Put the tie-rods and frame fixing the battery in position.. . . . . . . . . . . .
12-14 mm spanners
14 mm ring spanner
12 mm box spanner
REMOVAL
TOOLS