CITROËN ID 19 Repair Manual page 28

ID 19 OPERATION No. ID 100-1 Replacement of engine gearbox
16 Disconnect the flexible petrol feed pipe from the pump.
17 Disconnect the accelerator control and the choke control from the carburettor
18 Disconnect the contact breaker feed wires from the coil.
Disconnect the ignition advance control from the distributor.
19 Disconnect the rubber return pipe to the reservoir from the pressure regulator valve .
Disconnect the suspension feed pipe from the pipe union in the distribution box (spanner 2219-T or 2221-T,
see Pl.61, fig.3).
Seal the pipe openings (see Pl.89) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
20 Disconnect the flexible feed pipe to the heating and demisting radiator from the steel pipe on cylinder head.
21 Remove the front suspension spheres (strap wrench 2223-T, see Pl.87, flg.1) and seal the apertures (see Pl.89)
22 Remove the exhaust pipe screen and remove the nuts from the engine fixing studs on the rear brackets
23 Remove the front wheels. Disconnect the flexible couplings (Bibax) from the gearbox driving plates . . . . . . . .
24 Remove the fixing screws securing crossmember to sidemembers. Do not mislay either the screws or the
adjusting shims between cross and sidemembers
25 Pass a chain sling (chain sling 1697-T, see P1.42) under the water pump casing. Lift the engine and withdraw
it from the vehicle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
26 Mount the engine-gearbox assembly on a stand (stand 2497-T, Pl.19)
ASSEMBLY
27A Adjust the rear flexible brackets
1. To adjust the lateral position of the brackets:
a) Measure the dimension on the engine-gearbox assembly. Position the gauge as shown on Pl.21
with the point of pin "A" engaged in the crossmember upper fixing hole, unscrew set screw "B"
and slide movable rod "C" so that the pin engages in the hole of plate "D" and in the hole of the
suspension arm. Tighten screw "B"
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
(cars delivered before July 1959) (adjusting fixture 1698-T, see Pl.21, 22,23 and 24):
. . . . . . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TOOLS
8 mm box spanner
Spanner or
2219-T 2221-T
Strap wrench 2223-T
. . . . . . 23 mm spanner
12 mm socket wrench
with extension
14 mm box spanner
Chain sling 1697-T
Stand 2497-T
26