CITROËN ID 19 Repair Manual page 326

320 OPERATION No. ID 532-3 : I.V& on the a'~namo ID 19
I
TOOLS
48 Insert the yellow field cable in the sheath.
49
Solder the terminal (14) on the end of the yellow cable and solder the connection on the field coils, then carefully
insulate the soldering.
NOTE - Never use killed hydrochloric acid, but special soldering paste or resin.
50 To assemble the end bearing plate (5) driving side:
4
Crease the bearing (11) with high melting point grease.
b) Place the bearing (11)
in the end plate and fix the plate (10) with rivets.
51
Insert the armature (7) in the end bearing brush holder (6).
Bring the brushes into contact with the commutator.
Make sure that the brush springs (32) are correctly positioned . . 7 mm box spanner
52 Insert the assembly of the armature and end bearing plate in the body of the dynamo.
Correct the output cable.
Engage the end bearing plate, driving side on the armature (7). Fix the two plates (5) and (6) by means of the screws
(4), tighten the nuts (33)
(serrated washers) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
10 mm box spanner
53 Fit the key (2). Fit the driving pulley, tighten the nut (34) (spring washer)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 mm box spanner
54 Test the dynamo on a bench:.
Dynamo without regulator, 'field on the positive terminal:
No load and cold: 6.5 volts at 950 r. p.m. maximum.
Under load and cold:
6.5 volts at 2850 r.p.m.: 32 amps on resistance.
Under load and warm: 6.5 volts at 3000 r.p.m.: 30 amps maximum.