CITROËN ID 19 Repair Manual page 77

ID
19
OPERATION No. ID 120-l : Work on
tirninggear Op. ID 120-l 75
38
39
40
41
42 Insert the rocker tappets into position,
after oiling them (use extractor 1608-T, see Pl. 17, fig. 1).
43
44
45
Fit the cylinder head (see Op. 112-1, paragraphs 18 to 29).
Fit the air filter and tube assembly (spring washers under the fixing nuts)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-17 mm box spanners
Fill the radiator while the engine is running.
REPLACEMENT OF ROCKER TAPPETS
To remove (see Pl. 1 and 3).
Drain the cooling system (radiator and cylinder block). Retain the water which contains anti-freeze.
Remove the air filter and tube assembly . . . ..*...............................................................
2-17 mm box spanners
Remove the cylinder head (see Op. ID 112- 1, paragraphs 3 to 17).
Remove the rocker tappets (extractor 1608-T, see Pl. 17, fig. 1).
NOTE - It is advisable to replace only one tappet at a time. Otherwise,
the replacement rocker tappet could drop
down the empty bore with its base up. In this position,
it would be almost impossible to withdraw it without
stripping the engine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To refit (see Pl. 1 and 3).
Check the sealing of the connections (oil and water).
TOOLS
Extractor 1608-T