Manifolds - CITROËN ID 19 Repair Manual

ID
19
OPERATION No. ID 141- 1
: Replacement of an inlet manifold
Op. ID 141-1 85
5
6
REMOVAL
Drain the radiator, retaining the water which contains anti-freeze.
Remove the carburettor (see Op. ID, 142-1, paragraphs 1 to 4).
Disconnect the heating pipe from the inlet manifold.
Remove the inlet manifold and the gasket between inlet manifold
andcylinderhead
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To strip the inlet manifold :
. Remove the petrol outlet pipe and the biconical union between pipe and manifold.
Remove the fixing sleeve of the heating pipe and the fibre joint.
Remove the cover plate of the inlet manifold . . . . . . . . . . . . . . . . . . . . . . . . . . . . . _ . . . . . . . . . . . . . . . . . . . . . . . . . . . .
REFITTING
To assemble the inlet manifold :
Place the cover plate in position and insert a gasket smeared with "Hermetic".
Fit the fixing sleeve of the heating tube and insert the fibre gasket.
Fit the petrol outlet pipe using a biconical union
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
anifold on the cylinder head,
inserting a Hugo Reinz gasket; tighten the fixing screw (plain washers
s). Connect the heating pipe to the inlet manifold inserting an elastic ring and tighten collar.. . . . . . . . .
Fit the carburettor (see Op. ID 142-1, paragraphs 5 to 10).
Fill the radiator with the engine running.
TOOLS
12 mm box spanner
12 mm spanner
12-19 mm box spanners
12 mm spanner
12-19 mm box spanners
12 mm box spanner