Replacement Of A Sealing Ring - CITROËN ID 19 Repair Manual

ID
19 OPERATION No. ID 3 14 - 1 : Wnrk on rhe
clutch
Op.ID 314-1
139
24 Fitthebrake unit..........................f................................................................
25
26
27
28 Remove the gearbox (see Op.ID 330-l).
29 Disconnect the clutch housing from the gearbox housing (see paragraphs 17 to
19 this operation).
30 Remove the sealing ring (11) from the drive shaft (20) (see Pl. 43).
31
32
33
34
35
36
b)
Place the paper gasket on the bearing and fit the bearing in position, the oil discharge duct towards the bottom (the
longest bearing is fitted on the left).
Make sure that the distance piece (114) is fitted.
Tighten the bearing fixing screws (3)
c) Insert the screws (1) (without tightening them) securing the support arms (2) (plain washers under the heads).
On the support arms fit the support fixture 1799-T
( see Pl. 42) and tighten the support fixture fixing screws.
Tightenthe support arm fixing screws(l) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Replace the mechanical brake connection cable and the brake cylinder connection pipes (spanner 2221-T, see ~1.61,
fig.3) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fit the thrust ball bearing and secure to the clutch fork by means of the springs (89).
Fit the gearbox and connect to the engine (see Op.ID 330-l)
Fill the gearbox (3.6 pints (2 litres) SAE, 90 EP oil).
REPLACEMENT OF A SEALING RING (Cyclam)
Removal
Refitting
Place the sealing ring (11) in position on the main shaft (20) (see P1.43)
Connect the clutch housing to the gearbox housing (see paragraph 22 this operation).
Fit the differential shaft, bearings and brake disc (see paragraph 23 this operation).
Fit the brake unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .._..............................
Fit the mechanical brake connection cable and the brake cylinder connection pipe (spanner 2221-T, see Pl. 61, fig. 3).
Replace the gearbox and secure it to engine (see Op.ID 330-l).
Fill the gearbox with 3.6 pints (2 litres SAE 90,
EP oil).
TOOLS
Support fixture 1799 -T
14 mm box spanner
12 mm spanner and
box spanner
14-19 mm box spanners
Spanner 2221-T
12 mm spanner and
box spanner
14-19 mm box spanners
Spanner 2221-T