CITROËN ID 19 Repair Manual page 169

ID
19 OPERATION No. ID 330-3 : Overhauling thegeavbox
Op.ID 330-3
163
39 To fit the shaft and bearing assembly (see P1.45):
Put the adjusting washers (4) and the distance pieces (5) previously prepared, in their respective positions.
Fit a paper joint on the housing.
Put the housing in position, the oil drain channel towards the bottom (the longer housing fitted on the left side).
Make sure that the distance piece (114) is in position.
Tighten the screws (3) fixing the housing.
I
Check the clearance between the teeth (see preceding paragraph).
Screw up, without tightening, the screws (1) fixing the brackets (2).
Fit on the bracket arms the straight edge 1799-T
(see P1.42) and tighten the screws fixing the straight edge.
Tighten the screws (1) fixing the bracket arms (plain washer under the head)
. . . . . . . . . . . . . . . . . . ., . . . . . . . . . . . . . . . . .
40
41
With the sliding gears and forks in the neutral position, fit the gearbox cover (insert a paper joint stuck with grease
on the cover).
Smear the thrust pads of the 3rd and 4th speed selector fork with grease to prevent them falling
out of position.
Make sure that the forks are properly engaged in the grooves of the sliding pinions.
Fit the centring screws. Fit the other screws.
To adjust the 3rd and 4th selector fork shaft (see P1.43, 46 and 47):
4
Pull the locking lever (66) so that washer(b just in contact with the circlip (65) and swing the support tube (70)
towards the front.
The fork is then in the 3rd speed position.
b) Screw the threaded stop screw (75) in order to bring the stop against the selector shaft. Then unscrew the screw
one eighth of a turn and tighten the locknut (76) ( p s anner MR-3691-80, see P1.57, fig.2) . . . . . . . . . . . . . . . . . . . . .
4
Carry out the same procedure for the 4th speed position after having swung the support tube (70) towards the
rear.
NOTE - This operation is no longer necessary on cars produced since January 1960.
TOOLS
14 mm box spanner
1799 -T straight edge
Spanner MR-3691-80
21 mm ring spanner