CITROËN ID 19 Repair Manual page 64

62
OPERATION
No.
ID
112- 3 : OverhauZing a cylinder head Op. ID 112-3 ID -19
b)
4
d)
e)
To assemble the inlet rocker shaft assembly (see Pl. 3):
First oil the inlet rocker shaft (44)
and then with the lubrication holes directed towards the bottom (on valve
side) place on it, beginning at the front:
1 long screw (3) complete with shaft fixing cap (33).
1 washer (37),
1 spring (45),
1 left hand rocker (34),
1 washer,
1 long screw complete with cap,
1 washer,
1 right hand rocker (35),
1 spring,
1 washer,
1 long screw complete with cap,
1 long screw complete with cap,
1 washer,
1 spring,
1 left hand rocker,
1 washer,
1 long screw complete with cap,
1 washer,
1 right hand rocker,
1 spring,
1 washer,
1 long screw complete with cap.
Fit the brackets and the inlet rocker shaft assemblies on the cylinder head.
Fit the water pump cover inserting a gasket smeared with "Hermetic".
Fit the water $ump and insert gasket
smeared with "Hermetic". Tighten the fixing nuts and bolts.
Fit the inlet pipe cover plates, the inlet manifold, the rear plate and water outlet assembly, inserting
gaskets smeared with "Hermetic". Tighten the fixing screws (plain washers under screw heads) . . . . . . . . . .
Fit the exhaust manifold inserting copper asbestos gaskets ;
fit the fixing brackets of the exhaust manifold screen
(the upper bracket which is the longest goes at the front).
Tighten the fixing nuts (spring washers) . . . . . . . . .
x.
T-
TOOLS
12-14-17 mm box spanners
12 mm spanner
4