CITROËN ID 19 Repair Manual page 305

ID
19
OPERATION No. ID 453-3 : Work on the brake hydraulic system
OD.
ID 453-3
299
29
30
31
32
33
34
35
36
To refit the accelerator pedal (see Pl. 27) :
First grease (graphite grease) the accelerator pedal pivot screw (13),
insert it in position and screw on the locknut
(12). Insert the screw in the pedal bearing (14),
making sure that the distance "b" = 0 to 1 mm and llc't = 0. 2
to 1.7 mm are correct. Lock the locknut (12)
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Fit the master cylinder control rod (7) complete with its locknut (8) on the brake pedal yoke (12).
OVERHAUL OF A REAR WHEEL CYLINDER
Dismantling (see Pl. 102):
Remove the bleed screw, the dust-proof caps (45), the pistons (46) and the circlip (47) . . . . . . . . . . . . . . . . . . . . . . . .
Remove the ring seals (49) from the pistons
(46).
Use
a
piece of
brass
wire flattened at one end.
Clean all the parts in alcohol only.
Assembly (see Pl. 102):
Place the circlip (47) in position.
Fit the ring seals (49) on the pistons (46). Oil the pistons
(46) with hydraulic fluid and fit them in the wheel
cylinder, after ensuring that they are free from scratches or traces of seizure.
Fit the dust caps (45) and the bleed screw
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . a....
TOOLS
17 mm spanner
10 mm box spanner
10 mm box spanner