CITROËN ID 19 Repair Manual page 208

202 OPERATION No. ID 393-
1 : Replacement of a pressure distribution block
ID l?
REMOVAL.
Remove the spare wheel, and the left-hand front wing. Remove the left-hand side protection panel . . . . . . . . . . . . . . . .
Release the pressure by unscrewing the pressure regulator bleed screw. Retighten the bleed screw . . . . . . . . . . . . . .
Disconnect from the pressure distribution block the rear suspension feed pipe union, disconnect the pressure inlet
pipe union and disconnect the front suspension feed pipe union (spanner 2221-T or 2219-T, see Pl. 61, fig. 3) . . .
Remove the pressure distribution block fixing screws and remove the distribution block. Do not lose the 2 distance
pieces . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
REFITTING.
Fit the distribution block and the fixing screws (insert the distance pieces between the distribution block and the
sidemember closing panel) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Working from top to bottom, fit on the pressure distributor,
the rear suspension feed pipe union, the pressure inlet
pipe union and the front suspension feed pipe union (spanner 2221-T or 2219-T, see Pl. 61, fig. 3) . . . . . . . . . . . .
4
Unscrew the bleed screw of the pressure regulator.
Start the engine and let it run for several minutes.
Retighten the bleed screw. Place the system under pressure. Check the unions for leakage.. . . . . . . . . . . . . . .
. . .
Fit the side protection panel.
Fit the wing and the spare wheel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TOOLS
7-12-14 mm box spanners
8 mm spanner
Spanner 2221-T or
2219-T
8 mm box spanner
8 mm box spanner
Spanner 2221-T or
2219-T
8 mm spanner
8-12-14 mm spanners
and box spanners
c