CITROËN ID 19 Repair Manual page 259

ID 19 OPERATION
No. ID 434- 1 : Work on
the
rear suspension
Op.ID 434-l 253
29
30
31
32
33
34
To remove the piston rod (4):
a)
Remove the connecting pin (5).
b)
Remove the fixing collar from the ball joint dust cover (6).
Withdraw the dust cover (6) towards the rear.
c)
Disconnect the piston rod (4) f rom the buffer support lever (7).
The rod (4) can be released from the lever (7)
only if the holes provided for the connecting pin (5) are parallel.
d)
Release the dust cover (2) from the suspension cylinder and remove the piston rod (4) together with dust covers
(2) and (6).
Remove the dust cover (6) from the piston rod (4).
Remove the clip securing the dust cover (2) to the piston rod (4) and remove the dust cover (2).
Refitting (see Pl .82).
To prepare the piston rod (4):
4
Engage the dust cover (2) on the piston rod and position it so that the overflow return connection is at right angles
to the hole for the connecting pin. Place the dust cover (2) in position on the milled portion of the piston rod and
fit the Ligarex clip (pliers 2483-T, see Pl. 17, fig.2); insert a rubber bush (10) . . . . . . . . . . . . . . . . . . . . . . . . . . . .
b)
Engage the flexible bush (14) on the dust cover (2).
Place the ball joint dust cover (6) on the piston rod (4).
Fit the piston rod (see paragraph 23, this operation).
Fit the rear wheel and wing.
Lower the car to the ground (jacking bracket 2505-T, see Pl. 111) . . . . . . . . ..I......
Retighten the pressure regulator bleed screw
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TOOLS
Pliers 2483-T
Jacking bracket 2505-T
14 mm box spanner
8 mm spanner