CITROËN ID 19 Repair Manual page 135

ID 19 OPERATION No.
ID 312- 1 : Replacement of the clutch
Op.ID 312-1
133
REMOVAL
Remove the gearbox (see Op.ID 330-1, paragraphs 1 to 17)
Disconnect the clutch from the engine flywheel and remove . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
REFITTING
d
To connect the clutch to the engine flywheel:
4
Make sure that the disc bearing faces on the clutch and on the flywheel are clean.
b)
Connect the clutch to the flywheel. Use a mandrel (mandrel 1712-T, see P1.40, fig.4) or a clutch shaft in order
to centre the disc.
When tightening the fixing screws make sure that the mandrel slides easily,
thus indicating that the disc has been
properly centred. Tighten the screws to 14.5 t
i.9
ft.lbs (2 t z.25 m.kg) (spring washers under heads).
Withdraw the mandrel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Replace the gearbox (see Op.ID 330-1, paragraphs 18 to 39).
TOOLS
12 mm box spanner
Mandrel 1712-T
12 mm box spanner