Mitel 6867i Administrator's Manual page 481

Configuring a Park/Pickup Key Using Mitel Web UI (for Asterisk, BroadWorks, Sylantro,
and ININ Call Managers)
For all phones you first configure the park and pickup keys at Advanced Settings -> Line 1-N
by entering the appropriate value based on the server in your network.
Note: Applicable values depend on the server in your network (Asterisk, BroadWorks,
Sylantro, ININ). See the table below for applicable values.
For the 6867i, 6869i, and 6873i IP phones, you can enter a key label and change the softkey
states at Operation->Softkeys and XML. The default state of the park configuration is
"connected". The default state of the Pickup configuration is "idle, outgoing". On the 6863i
and 6865i IP phones, you can enter a key label at Operation->Softkeys and XML.
Park/Pickup Call Server Configuration Values
SERVER
Asterisk
Sylantro
BroadWorks
ININ PBX
Use the following procedure to configure the park/pickup call feature using the Mitel Web UI.
MITEL WEB UI
For the 6867i/6869i/6873i:
1. Click on Advanced Settings ->Line 1 (you can select any line)
2. Under Advanced SIP Settings in the "Park Pickup Config" field, enter the appropriate
value based on the server in your network.
Notes:
1. For values to enter in this field, see the table
on
Values"
2. Leave the park/pickup configuration field blank to disable the park and pickup
feature.
PARK VALUES*
70
*98
*68
callpark
.
page 5-220
Operational Features
PICKUP VALUES*
70
*99
*88
pickup
"Park/Pickup Call Server Configuration
5-220