Mitel 6867i Administrator's Manual page 480

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
Call Park/Pickup Configuration Precedence Rule
Note: Not applicable when using the MiCloud Telepo for Service Providers call manager
for park/pickup functionality.
For users upgrading from Release 2.x firmware, the "softkeyN value" parameter will be used
if the "sip lineN park pickup config" parameter is not set. If the per-line park pickup config
parameter is set, the following precedence rule will apply:
1. "sip lineN park pickup config: <park_value>;<pickup_value>;<asterisk | sylantro |
broadworks>" will override
"sip park pickup config: <park_value>; <pickup_value>; <asterisk | sylantro | broadworks
| inin>"
2. "sip park pickup config: <park_value>;<pickup_value>;<asterisk | sylantro | broadworks |
inin>"
will override
"softkeyN value: <park_or_pickup_value>" (or topsoftkeyN, prgkeyN, or expmod1 keyN).
3. "softkeyN value: <asterisk|sylantro|broadworks|inin>;<park_or_pickup_value>"
will have lowest priority.
For example, the following has been configured on the phone:
softkey1 type: park
softkey1 label: parkCall
softkey1 states: connected
softkey1 value: broadworks;*68
softkey2 type: pickup
softkey2 label: pickupCall
softkey2 states: idle, outgoing
softkey2 value: broadworks;*88
sip park pickup config: 70;70;asterisk
sip line1 park pickup config: *78;*98;broadworks
If the active call is using Line1, the phone will use the BroadWorks method for park (*78) and
pickup (*98) since per-line has the highest precedence.
If the active call is using any other line except Line1, the phone will use the Asterisk method
for park (70) and pickup (70) since it has precedence over the softkey value.
CONFIGURATION FILES
For specific parameters you can set in the configuration files, see Appendix A, the section,
"Expansion Module Key Settings for M680i and M685i"
and
"Programmable Key Settings"
5-219
on
page A-240
on .
page A-228
, on
"Softkey Settings" page A-218