Mitel 6867i Administrator's Manual page 131

PARAMETER PARAMETER IN
IN MITEL WEB UI
IP PHONE UI
N/A DTMF Method
(Global and
Per-Line)
N/A RTP Encryption
(Global and
Per-Line)
Codec Preference List
You can configure the following codec preference list settings.
PARAMETER PARAMETER IN
IN MITEL WEB UI
IP PHONE UI
N/A Basic Codecs
(G.711 u-Law,
G.711 a-Law,
G.729)
N/A Customized
Codec
Preference List
PARAMETERS IN DESCRIPTION
CONFIGURATION
FILES
sip dtmf method Sets the dual-tone multi-frequency
(DTMF) method to use on the IP phone on
(global)
a global or per-line basis. Valid values are
0 (RTP), 1 (SIP INFO), or 2 (BOTH).
sip lineN dtmf
Default is 0 (RTP).
method
(per-line)
For more information, see Chapter 4,
"Real-time Transport Protocol (RTP)
Settings"
sip srtp mode This parameter determines if SRTP is
enabled on this IP phone, as follows:
(global)
3. If set to 0, then disable SRTP.
sip lineN srtp mode 4. If set to 1 then SRTP calls are
(per-line)
5. If set to 2, then SRTP calls only are
For more information, see Chapter 4,
"Real-time Transport Protocol (RTP)
Settings"
PARAMETERS IN DESCRIPTION
CONFIGURATION
FILES
sip use basic Enables or disables basic codecs.
codecs Enabling this parameter allows the IP
phone to use the basic Codecs when
sending/receiving RTP packets. Valid
values are 0 (disabled) and 1 (enabled).
Default is 0 (disabled).
For more information, see Chapter 4,
"Real-time Transport Protocol (RTP)
Settings"
sip customized Specifies a customized Codec preference
codec list which allows you to use the preferred
Codecs for this IP phone.
For more information, see Chapter 4,
"Real-time Transport Protocol (RTP)
Settings"
Administrator Level Options
on page 4-83.
preferred.
generated/accepted.
on page 4-83.
on page 4-83.
on page 4-83.
3-61