Mitel 6867i Administrator's Manual page 158

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
The network administrator chooses which of these parameters (if any) are supplied to the IP
phone by the DHCP server. The administrator must configure the phone manually to provide
any required network parameters not supplied by the DHCP server.
Enabling/Disabling DHCP Using the Configuration Files
Use the following procedure to enable/disable DHCP on the phone using the configuration files.
CONFIGURATION FILES
For specific parameters you can set in the configuration files, see Appendix A, the section,
"Network Settings"
Enabling/Disabling DHCP Using the IP Phone UI
Use the following procedure to enable/disable DHCP on the phone using the IP Phone UI.
IP PHONE UI
For the 6863i/6865i:
1. Press on the phone to enter the Options List.
2. Select Administrator Menu.
3. Enter your Administrator password.
Note: The IP Phones accept numeric passwords only.
4. Select Network Settings.
5. Select option DHCP.
6. Press Change to set "Use DHCP?" to "Yes" (enable) or "No" (disable).
7. Press Done to save the changes.
For the 6867i/6869i:
1. Press
2. Press the Advanced softkey.
3. Enter the Administrator password using the keypad. Default is "22222".
4. Select Network > Settings.
5. In the "Use DHCP?" checkbox, press the
6. Press the Save softkey.
7. Press the
For the 6873i:
1. Press
4-5
on .
page A-9
on the phone to enter the Options List.
button, the button, or the Quit softkey to return to the idle screen.
on the phone to enter the Options List.
button to enable or disable DHCP.