Mitel 6867i Administrator's Manual page 199

For the 6863i/6865i:
1. Press on the phone to enter the Options List.
2. Select Administrator Menu.
3. Select Network Settings.
4. Select Type of Service DSCP.
5. Select Type of Service SIP.
or
Select Type of Service RTP.
or
Select Type of Service RTCP.
6. Enter a value for "Type of Service SIP". Default is 26.
or
Enter a value for "Type of Service RTP". Default is 46.
or
Enter a value for "Type of Service RTCP". Default is 46.
Valid values are 0 to 63.
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled,
you will need to map the applicable priority to the Protocol setting as shown in the
first table in
information, see the section
7. Press Done (3 times) to save the changes.
Note: The session prompts you to restart the IP phone to apply the configuration settings
8. Select Restart.
For the 6867i/6869i:
1. Press on the phone to enter the Options List.
2. Press the Advanced softkey.
3. Enter the Administrator password using the keypad. Default is "22222".
4. Select Network > DSCP.
5. Enter a value for "Type of Service SIP". Default is 26.
or
Enter a value for "Type of Service RTP". Default is 46.
or
Enter a value for "Type of Service RTCP". Default is 46.
Valid values are 0 to 63.
Note: If you change the ToS/DSCP setting for a Protocol, and VLAN is enabled,
you will need to map the applicable priority to the Protocol setting as shown in the
first table in
information, see the section
6. Press the Save softkey.
"DSCP Range/VLAN Priority Mapping"
"Configuring VLAN (optional)"
"DSCP Range/VLAN Priority Mapping"
"Configuring VLAN (optional)"
Network Settings
on page 4-44 For more
on page 4-48.
on page 4-44 For more
on page 4-48.
4-46