Mitel 6867i Administrator's Manual page 242

Mitel 6800 Series SIP Phone Release 4.2.0 Administrator Guide
If the customized codec preference list is configured as "All", the phone will set the codec order
of preference as per the following table:
PREFERENCE
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
You can specify a customized codec preference list on a global-basis using the configuration
files or the Mitel Web UI.
OUT-OF-BAND DTMF AND DTMF METHOD
The IP phones support out-of-band Dual-Tone Multifrequency (DTMF) mode as referenced in
RFC2833. In the Mitel Web UI, you can enable or disable this feature as required. The
"out-of-band DTMF" is enabled by default. In out-of-band mode, the DTMF audio is
automatically clamped (muted) and DTMF digits are not sent in the RTP packets. You can
configure out-of-band DTMF on a global-basis using the configuration files or the Mitel Web UI.
An additional feature on the IP phone allows you to select the DTMF method that the phone
uses to send DTMF digits from the IP phone via INFO messages. You can set the DTMF method
as Real-Time Transport Protocol (RTP), SIP INFO, or both. You can configure the DTMF method
on a global or per-line basis using the configuration files or the Mitel Web UI.
4-89
PAYLOAD
0
18
113
110
111
112
98
97
115
96
9
8
118
119
121
CODEC
G711u/8000
G729/8000
L16/16000
G711u/16000
G711a/16000
L16/8000
G726-16/8000
G726-24/8000
G726-32/8000
G726-40/8000
G722/8000
G711a/8000
AMR (Licensed feature)
AMR-WB (G.722.2) (Licensed
feature)
G.722.1