Table of Contents
Advertisement
C
G
ONFIGURING
LOBAL
S
SNMP
ETTINGS FOR
Use the Administration > SNMP (Configure Global) page to enable SNMPv3
service for all management clients (i.e., versions 1, 2c, 3), and to enable
trap messages.
CLI R
EFERENCES
"snmp-server" on page 658
◆
"snmp-server enable traps" on page 661
◆
P
ARAMETERS
These parameters are displayed:
Agent Status – Enables SNMP on the switch. (Default: Enabled)
◆
Authentication Traps
◆
trap managers whenever an invalid community string is submitted
during the SNMP access authentication process. (Default: Enabled)
Link-up and Link-down Traps
◆
whenever a port link is established or broken. (Default: Enabled)
W
I
EB
NTERFACE
To configure global settings for SNMP:
Click Administration, SNMP.
1.
Select Configure Global from the Step list.
2.
Enable SNMP and the required trap types.
3.
Click Apply
4.
Figure 222: Configuring Global Settings for SNMP
6. These are legacy notifications and therefore when used for SNMPv3 hosts, they must be
enabled in conjunction with the corresponding entries in the Notification View
– 403 –
| Basic Administration Protocols
C
15
HAPTER
Simple Network Management Protocol
– Issues a notification message to specified IP
6
– Issues a notification message
6
406).
(page
Advertisement
Table of Contents
Troubleshooting
