Configuring Amac Address Filter - Edge-Core ES3510MA Management Manual

C MAC
ONFIGURING A
A F
DDRESS ILTER
W I
EB NTERFACE
To configure link detection on switch ports:
Click Security, Network Access.
1.
Select Configure Interface from the Step list.
2.
Click the Link Detection button.
3.
Modify the link detection status, trigger condition, and the response for
4.
any port.
Click Apply.
5.
Figure 156: Configuring Link Detection for Network Access
Use the Security > MAC Authentication (Configure MAC Filter) page to
designate specific MAC addresses or MAC address ranges as exempt from
authentication. MAC addresses present in MAC Filter tables activated on a
port are treated as pre-authenticated on that port.
CLI R
EFERENCES
"Network Access (MAC Address Authentication)" on page 641
◆
C U
OMMAND SAGE
Specified MAC addresses are exempt from authentication.
◆
◆ Up to 65 filter tables can be defined.
There is no limitation on the number of entries used in a filter table.
◆
P
ARAMETERS
These parameters are displayed:
Filter ID – Adds a filter rule for the specified filter.
◆
◆ MAC Address – The filter rule will check ingress packets against the
entered MAC address or range of MAC addresses (as defined by the
MAC Address Mask).
– 283 –
C 14
HAPTER
Network Access (MAC Address Authentication)
| Security Measures