Table of Contents
Advertisement
Figure 5: Removing the CX2550 M6 or CX2560 M6 server node (C)
▶ Once the server node has been pulled to a position where the "Near to
END" label (1) is visible, use the other hand to support the bottom of the
server node until the server node has been pulled out.
4.5
Removing the server node dummy module
The CX400 M6 system must always run with closed node bays. It is only
allowed to leave a bay open for a limited time in case of repairing a
server node (for example). In the meantime all remaining server nodes
run in throttling mode (with reduced performance).
CAUTION
▶
Follow the safety instructions in
CX400 M6
Upgrade and Maintenance Manual
Basic hardware procedures
"Important information" on page
25.
45
Advertisement
Table of Contents
