Table of Contents
Advertisement
Chapter 3
Installing the System
This chapter describes the work of preparing for installation, mounting a chassis in a
rack, and mounting optional components.
Preparing the Necessary Tools/Information for Installation
■
Confirming Delivered Components
■
Confirming the Rack
■
Mounting the Chassis in a Rack
■
Mounting Optional Components
■
3.1
Preparing the Necessary Tools/
Information for Installation
This section describes the tools and information that are required in installation.
Have these prepared before starting installation work.
Table 3-1 List of Necessary Tools
Name
Phillips screwdriver (#2)
Stepladder
ESD mat and antistatic wrist strap
Lifter
(hydraulic or mechanical jack)
System management terminal
(ASCII terminal, workstation, terminal server, patch
panel connected to terminal server, etc.)
Use
Used to attach cable support brackets and mount
optional components
Used for mounting at high locations in racks
Used in the work of mounting optional components
Used in the work of mounting chassis in racks
Used to connect to the XSCF and for the work of
checking and configuring the XSCF firmware
39
Advertisement
Table of Contents
Troubleshooting
