To Connect The Sc Serial Management Port; To Connect The Sc Network Management Port; Figure 2-10 System Controller Serial And Network Ports, Rear Of Chassis - Fujitsu SPARC Enterprise T1000 Installation Manual

To Connect the SC Serial Management Port

▼
The system controller serial management port is marked SER MGT (
FIGURE 2-10
Note – Use the SC serial management port only for server management. It is the
default connection between the system controller and a terminal or a computer.
Caution – Do not attach a modem to this port.
●
Connect a Category 5 cable from the SER MGT serial management port to the
terminal device.
When connecting either a DB-9 or a DB-25 cable, use an adapter to perform the
crossovers given for each connector.

To Connect the SC Network Management Port

▼
The system controller network management port is marked NET MGT (
Note – The SC network management port is configured by default to retrieve
network settings via Dynamic Host Configuration Protocol (DHCP) and allow
connections using Solaris Secure Shell (SSH
settings for your network. Instructions are given in
●
Connect a Category 5 cable from the NET MGT network management port to your
network switch or hub.
22 SPARC Enterprise T1000 Server Installation Guide • April 2007
SER MGT NET MGT
System Controller Serial and Network Ports, Rear of Chassis
®
). You might need to modify these
Chapter 3.
).
FIGURE 2-10
).
FIGURE 2-10