Setting Up the Server
Creating a WWN Instance Management Table for Storage System
Enter the results in the "Physical slot name" column of the "WWN instance management table for
Physical slot name
This completes the "WWN instance management table for the server".
Creating a WWN Instance Management Table for Storage
Create a "WWN instance management table for storage system" (provided in
ment Table Templates" (page
(Example) When there are two ports on the ETERNUS DX/AF storage systems:
CA name in the ETERNUS DX/AF storage systems
The WWN for each CA in the ETERNUS DX/AF (check using ETERNUSmgr or ETERNUS Web GUI)
An arbitrarily-chosen alias name for each CA that may be used when setting up the fjpfca driver
This use of "alias name" differs from the "alias name" that is specified when setting Fibre Channel switch
zoning. However, it is recommended to set both aliases to the same name.
T_ID (SCSI target ID)
The SCSI target ID (decimal value) that is to be defined for each CA (check using ETERNUSmgr or ETERNUS
For switch connections, the SCSI target ID is irrelevant to the physical protocol, however it must be defined
as a Solaris OS SCSI driver setting. Values matched to the server environment and connection state of the
devices must be set beforehand.
It is recommended to set the same target ID to CAs that configures a multipath.
FUJITSU Storage ETERNUS DX, ETERNUS AF Configuration Guide -Server Connection- (Fibre Channel) for Oracle Solaris
25)) that summarizes information relating to CA in the ETERNUS DX/AF stor-
Copyright 2017 FUJITSU LIMITED
Physical path name
"Appendix A Various Manage-