Canon imageRUNNER ADVANCE C350 series Service Manual page 164

2
Technical Explanation > External Auxiliary System > Controls > Energy Saving Function
Standby
This is the mode that the machine is running or the machine is ready to start operation. All the
power is supplied.
Sleep Standby
This mode indicates that only the display is turned off while the power of other parts is all
supplied. The machine gets into this state when a PDL job is submitted during sleep.
Sleep 1
In the case of the following:
Settings/Registration > Preferences > Timer/Energy Settings > Sleep Mode Energy Use >
"High"
The Control Panel is not active (the light is off) and the 24V power on the DC Controller PCB
is not supplied. The 12V power is supplied. The machine gets into the Sleep Standby mode
when a print job is submitted and the Standby mode when the power supply switch on the
Control Panel is pressed.
In the case of the following, the machine gets into this mode even if "Sleep Mode Energy
Use" is set "Low".
• The device is connected to the IC CARD READER BOX-A1.
• Any mode other than "Auto" is specified for fax reception (RX) mode.
Deep Sleep
In the case of the following:
Settings/Registration > Preferences > Timer/Energy Settings > Sleep Mode Energy Use >
"Low" (Default: "Low")
Only the 3.3V is supplied. The machine gets into the Sleep Standby mode when a print job
is submitted and the Standby mode when the power supply switch on the Control Panel is
pressed.
Regardless of the machine condition, the power of the Cassette Heater is always supplied
when the Environment switch is turned ON.
2 Technical Explanation > External Auxiliary System > Controls > Energy Saving Function
The following descriptions are conditions for not entering DEEP SLEEP.
Software status
Common
• Settings/Registration > Preferences > Timer/Energy Settings > Sleep Mode Energy Use is
set to "High".
• Settings/Registration > Preferences > Timer/Energy Settings > Sleep Mode Exit Time
Settings is set (and not blank).
Network
• Settings/Registration > Preferences > Network > TCP/IP Settings > IPSec Settings > Use
IPSec is set to "ON".
• Settings/Registration > Preferences > Network > SMB Server Settings >Use SMB Server is
set to "ON".
• Settings/Registration > Preferences > Network > NetWare Settings > Use NetWare is set to
"ON".
• Settings/Registration > Preferences > Network > Ethernet Driver Settings > Auto Detect is
set to "OFF" and "1000 Base-T" is set for "Ethernet Type".
• Settings/Registration > Preferences > Network > IEEE802.1X Settings > Use IEEE802.1X
is set to "ON".
Fax
• Settings/Registration > Function Settings > Receive/Forward > Fax Settings > Selecting
Reception Mode is not set to "Auto RX".
• Settings/Registration > Function Settings > Receive/Forward > Fax Settings > Auto
Reception Switching is set to "ON".
• Settings/Registration > Function Settings > Receive/Forward > Fax Settings > Remote
Reception is set to "ON".
• Settings/Registration > Function Settings > Send > Fax Settings > Set Line > Modem Dial
in Settings > Line 1 or Line 2 is set to "ON".
• Settings/Registration > Function Settings > Receive/Forward > Fax Settings > Number
Display Settings > Line 1 or Line 2 is set to "ON".
Hardware status
• Copy Control Interface Kit-A1 is connected.
• The host machine (such as a PC) is connected to the USB Device.
• The storage is connected to the USB host.
• A device (general USB devices such as the IC Card Reader not used by host machine's
functions) used by MEAP is connected to the USB host.
2-121
T-2-60
T-2-61
2-121