ini File Field Name
AuthorizedTPNCPServers
BaseUDPPort
BootPRetries
BootPSelectiveEnable
BronzeServiceClassDiffServ
DisableH100ClocksOnTrunk
Failure
DisableNetRefOnTrunkFailure
DisableTPNCPEvent
EnableDetectRemoteMAC
Change
User's Manual
Table 12-4: Infrastructure Parameters
Description
Sets the IP address of TPNCP
authorized server.
Range = IP address in dotted notation
xxx.xxx.xxx.xxx
Defines the lower boundary of UDP
ports to be used by the board. The
upper boundary is calculated on the
basis of BoardBaseUDPPort + 10 *
(Number of Channels). This
parameter value must be a multiple of
10.
Defines the number of BootP retries
that the board sends during start-up.
The board stops issuing BootP
requests when either an AA122BootP
reply is received or the Number Of
Retries is reached. This parameter
takes effect only after the next board
reset.
Configures the board so that it will
only accept BootP replies, from
AudioCodes proprietary BootP-TFTP
Software.
1 = Enable; 0 = Disable
Sets the DiffServ for the Bronze
service class content.
Disables the H.100 clock's output
when the PSTN reference trunk fails.
0 = Disable
1 = NetRef
2 = A\B
3 = All
0 = Enables the NetRef signal when
the PSTN reference trunk fails.
1 = Disables the NetRef signal when
PSTN reference trunk fails.
Disables Events Reporting. For the
selected event, refer to enumerator
acTEvent. Range = nn = TPNCP
EventID to hide. Refer to the VoPLib
manual for additional information.
Allows for the detection of an
incoming RTP stream from a changed
remote MAC address. Used for board
230
Digital Mediant 1000
Host/Manual
Valid
Default Value
Range
0.0.0.0
See Descr.
4000
0 to 55000
3
1 to 14
0
0 or 1
10
0 to 56
0
0 to 3
0
0 or 1
1
See Descr.
3
0 to 3
Document # LTRT-66401