AudioCodes Mediant 1000 User Manual page 216

ini File Field Name
EnableDSPIPMDetectors
EnableEchoCanceller
EnableFaxModemInband
NetworkDetection
EnablePatternDetector
EnableRFC2658Interleaving
EnableSilenceCompression
EnableStandardSIDPayload
Type
EnableSTUModemDetection
EnableTrunkTestingTones
EVRCRate
User's Manual
Table 12-2: Media Processing Parameters
Description
recommendation.
0 = Disable; 1 = Enable
Enables or disables DSP IP Media
Detectors if allowed in the Feature
Key. Enabling this parameter might
reduce the board channel capacity.
0 = Disable; 1 = Enable
Enables or disables the Echo
Canceler.
0 = Disable; 1 = Enable
Enables or disables inband network
detection related to fax/modem.
Enables or disables activation of the
PD (Pattern Detector).
0 = Disable; 1 = Enable
When enabled, RTP packets include
an interleaving byte for VBR coders.
0 = Disable; 1 = Enable
Enables or disables Silence
Suppression Mode.
0 = Disable =
SILENCE_COMPRESION_DISABLE
1 = Enable =
SILENCE_COMPRESION_ENABLE
2 = Enable without adaptation =
SILENCE_COMPRESION_ENABLE
_NOISE_ADAPTATION_DISABLE
When set to 1 (Enable), SID packets
are sent with the RTP SID type (RFC
3389).
0 = Disable; 1 = Enable
Enables or disables detection of two
tones required for an STU modem.
0 = Disable; 1 = Enable
Enables or disables trunk testing
tones.
0 = Disables trunk testing tones
1 = Enables trunk testing tones
This parameter is used to configure
the EVRC coder bit rate.
0 = Variable Rate
216
Digital Mediant 1000
Host/Manual Valid
Default Value Range
0 0 or 1
1 0 or 1
0 0 to 1
0 0 or 1
0 0 or 1
0 0 to 2
0 0 or 1
0 0 or 1
0 0 or 1
0 0 to 3
Document # LTRT-66401