AudioCodes Mediant 1000 User Manual page 318

To prepare the Mediant 1000 for Multiple IPs (MI) and VLANs, take
these 10 steps:
Ascertain values for the following parameters:
1.
Note:
OAM network:
•
IP/Subnet/GW = 10.31.174.50 / 255.255.0.0 / 0.0.0.0
•
VLAN ID = 4
Call Control network:
•
IP/Subnet/GW = 10.32.174.50 / 255.255.0.0 / 0.0.0.0
•
VLAN ID = 5
Media network:
•
IP/Subnet/GW = 10.33.174.50 / 255.255.0.0 / 10.33.0.1
•
VLAN id = 6
Note:
In the ini file, set the VLAN parameters.
1.
If the BootP/TFTP to be on the same network as the operational OAM network,
a.
the Native VLAN parameter is equal to the OAM VLAN (both equal to the PVID of
the switch port the board to which it is connected). According to the sample
parameters in this example (see above), the OAM Network VLAN ID = 4. The
following is an example of the VLAN parameters in the ini file with values
according to the sample parameters above:
vlanOamVlanId=4
vlanNativeVlanId=4
In the switch port, configure the PVID = 4.
b.
Set the Call Control network VLAN ID and Media network VLAN ID. According to
c.
the sample parameters in this example (see above), the Call Control network
VLAN ID = 5 and the Media network VLAN ID = 6 . The following is an example of
these parameters in the ini file with values according to the sample parameters
above:
vlanControlVlanId=5
vlanMediaVlanId=6
Set the vlanMode parameter to 1. The following is an example of this parameter
d.
in the ini file:
User's Manual
The values provided are sample parameters only and are to be replaced
with actual values appropriate to your system.
The board is configured only with one default gateway on the media
network. Additional
WEB/SNMP/TPNCP and even via the ini file.
routes can be configured
318
Digital Mediant 1000
statically by
Document # LTRT-66401