Snmp Interface Details - AudioCodes Mediant 1000 User Manual

The following proprietary traps are supported in Mediant 1000:
•
acBoardFatalError - Sent whenever a fatal board error occurs.
•
acBoardConfigurationError - Sent when a board's settings are illegal - the trap
contains a message stating/detailing/explaining the illegality of the setting.
•
acBoardTemperatureAlarm - Sent when a board exceeds its temperature limits.
•
acBoardEvResettingBoard - Sent after a board is reset.
•
acBoardEvBoardstarted - Sent after a board is successfully restored and
initialized following reset.
•
acgwAdminStateChange - Sent when Graceful Shutdown commences and
ends. (Currently supported in MEGACO only)
•
acBoardEthernetLinkAlarm - Ethernet Link or links are down.
•
acActiveAlarmTableOverflow - An active alarm could not be placed in the
active alarm table because the table is full.
•
acAudioProvisioningAlarm - Raised if the Mediant 1000 is unable to provision
its audio.
•
acOperationalStateChange - Raised if the operational state of the node goes to
disabled. Cleared when the operational state of the node goes to enabled.
•
acKeepAlive – part of the NAT traversal mechanism. If the STUN application in
the Mediant 1000 detects a NAT then this trap is sent out on a regular time laps -
9/10 of the acSysSTUNBindingLifeTime object. The AdditionalInfo1 varbind has
the MAC address of the Mediant 1000.
•
acNATTraversalAlarm - When the NAT is placed in front a Mediant 1000, it is
identified as a symmetric NAT - this alarm is raised. It is cleared when a non-
symmetric NAT or no NAT replace the symmetric one.
•
acEnhancedBITStatus - This trap is used to for the status of the BIT (Built In
Test). The information in the trap contains board hardware elements being tested
and their status. The information is presented in the additional info fields.
•
acPerformanceMonitoringThresholdCrossing - This log trap is sent out for
every time the threshold of a Performance Monitored object is crossed. The
severity field is 'indeterminate' when the crossing is above the threshold and
'cleared' when it goes back under the threshold. The 'source' varbind in the trap
indicates the object for which the threshold is being crossed.
In addition to the listed traps the Board also supports the following standard traps:
•
authenticationFailure
•
coldStart
•
dsx1LineStatusChange
8.1.5

SNMP Interface Details

This section describes details of the SNMP interface needed when developing an Element
Management System (EMS) for any of the TrunkPack-VoP Series products, or to manage
a device with a MIB browser.
SNMP can be encoded over IPSec. For more details, refer to the Appendix, 'Security' on
page 279.
For ini file encoding, refer to the Appendix 'Utilities' on page 289.
User's Manual 124
Digital Mediant 1000
Document # LTRT-66401